Control-company 4115 RADIO-SIGNAL REMOTE THERMOMETER User Manual download pdf (Page 9)

3. Replace the battery compartment door.

Replace the batteries when the low-battery indicator of the indoor tempera-

ture lights up. (Repeat the steps described in section, “Before Beginning”.)

TWO SENSORS

Each remote module has two sensors. The internal (ambient) sensor is

located inside the case toward the bottom of the remote module. It is ideal

for monitoring air temperatures. It is automatically in use and in the circuit

when the external sensor is not plugged in.

The second sensor is the external one. Use it to monitor liquids, gases, and

semisolids. The external sensor is automatically in use when it is plugged

into the remote module. Plugging in the external sensor removes the

internal sensor from the circuit. The waterproof external sensor and 10-foot

cable perform accurately even when both are under water.

GETTING STARTED

Once batteries are in place for the remote units, they will start transmitting

temperature readings at 30-second intervals.

The main unit will also start searching for signals for about 2 minutes once

batteries are installed. Upon successful reception, the individual channel

temperatures will be displayed on the top line and the indoor temperature

on the bottom line. The main unit will automatically update its readings at

about 30-second intervals.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Control-company 4115 RADIO-SIGNAL REMOTE THERMOMETER User Manual Page 9